Wlan BOX WB100A - Call Transferring


48 VoIPNetworkServicesGmbH,Justus‐von‐Liebig‐Str.26,31535Neustadt 
5 Functions
5.1 Making Calls
 Dial the number directly and wait for 5 seconds (default No Key Entry Timeout).
 Dial the number with ending char #, WB100A will dial out immediately
 Dial the phone number which matches one dial rule, WB100A will dial out immediately, no
need to press # or wait for 5 seconds.
5.2 Call Waiting
 Enable waiting feature in SIP-->Line1-->supplementary Service→Call Waiting (default is
Enable)
 While in conversation, user will hear a special stutter tone if there is another incoming
call.
 User then can press “*77” (or Flash button)to put the current call party on hold
automatically and switch to the other call. Pressing “*77”(or Flash button) toggles between
two active calls.
5.3 Call Hold
 While in conversation, pressing the “*77”(or Flash button), will put the remote end on hold.
 Pressing the “*77”(or Flash button) again, will release the previously Hold state and
resume the bi-directional media.
5.4 Call Transferring
WB100A supports blind transfer and attended transfer.
5.4.1 Blind Transfer
Assuming that call party A and party B are in conversation, A wants to Blind Transfer B to C
 Party A dials *98, A will hear dialing tone
 Dial party C’s number, and press # (or wait for 5 seconds) to call C, then C will ring, A will
 be disconnected.
 If C answer the call, B and C can go on talking.
5.4.2 Attended Transfer
Assuming that call party A and B are in conversation. A wants to Attend Transfer B to C:
 Party A dials *77 to hold B, A will hear dialing tone
 Dial party C’s number, and press # (or wait for 5 seconds) to call C, then A will hear
ringing tone.
 If C answer the call, A will talk with C firstly
 If C wants to talk with B, A press “*98” to transfer, and then C will talk with B. If C does not
 talk with C successfully, A will talk with B again.