Initial setup
7
2.2 Installation and connection
> Unpack the automatic coffee machine.
> Check the machine for possible damages during transportation.
> While installing the automatic coffee machine, follow the hazard instructions given under chapter
“1.2 Hazard instructions” on page 2 and in this chapter as well as the following instructions:
> Place the automatic coffee machine on a stable, horizontal surface that is waterproof and
heat-resistant.
> Protect the mains cable from damage:
- Do not kink or trap the mains cable.
- Protect the mains cable from sharp edges, moisture, heat or oil.
> Do not allow the cable to hang over the edge of the table or the corner of the table.
> Protect the automatic coffee machine from moisture and weather infl uences and do not use the
automatic coffee machine outdoors.
> Install the device at least 85 cm, if necessary, even higher, above fl oor level.
> Allow a space of at least 300 mm for removal of the brewing unit, for maintenance and cleaning.
> Maintain a space of at least 5 cm at the sides.
Assembly
To Next Page
Loading...
