WMF 1000pro S - Preparing Milk and Milk Foam

Operation
33
3.3.7 Preparing milk and milk foam
The coffee machine prepares hot milk and milk foam at the touch of a button.
Non-foamed hot milk:
> Place an appropriate drinking vessel under the All-In-One spout.
Slide the All-In-One spout to the top position.
If you forget this step on the WMF 1000 S, you will be reminded by the display.
> Briefl y press the milk button.
A mug of hot milk is prepared.
After the milk is dispensed, the All-in-One spout shall again be pushed slightly downwards.
Milk foam
> Place an appropriate drinking vessel under the All-In-One spout.
> Only on the WMF 1000 S (not the WMF 1000pro S): Push the All-In-One spout slightly downwards.
> Press and hold the milk button till the desired quantity of hot milk foam is prepared.
Tip: Milk or milk foam can drip a little after dispensing. It is best to hold your cup for a little while longer
after dispensing under the All-In-One spout, or place a small collecting vessel under the spout.
Tip: Milk can also drip, if the milk container is full and at the same time the All-In-One spout is in a lower
position. Push the spout slightly upwards after the beverage is dispensed.