Operation
45
3.6.4 Basic settings
Following settings can be adjusted:
Basic settings
Language* Time*
Switch off time* Date*
Switch-on time Display of time/date
Eco-Modes (energy saving mode)* Water hardness*
Brewing temperature Water fi lter*
Illumination Special information tone
Offi ce functions Contrast display
Warm up rinsing Factory settings
The basic settings marked with a * have already been set during the commissioning. However, you can subsequently change these values too.
The description for this can be found under the chapter “2.9 Initial setting” on page 14
.f.
In order to adjust the basic settings, proceed as follows:
> Press
P
button.
> Browse with
+
for basic settings.
select program
browse: +
Select the basic
settings
To Next Page
Loading...
