WMF 1200F - Water Filter; Capacity; SB Mode (Self-Service Mode)

19
User Manual WMF1200F
Start-up
Water filter
water lter: no
OK: P change: -/+
DI_02_09_06
If water filter is set to yes , the filter should be
rinsed after the SB mode display.
Capacity
capacity: x
OK: P change: -/+
DI_02_09_09
... with water filter
The capacity of the water filter is set here.
(The capacity of the water filter can be found in
the water filter documentation.)
 Confirm the desired setting with
SB mode (self-service mode)
SB mode: no
OK: P change: -/+
DI_02_09_11
PIN entry and PIN protection
w page 38
When set to yes , the functional pads are not
displayed. The functional pads are displayed again
by touching and holding (at least 3seconds) the
unilluminated Ppad.
The SB mode function can be protected by aPIN.
place 3L container
under spout
DI_02_09_07
 Place acollection container with approx.
3liters capacity under the combi spout
When rinsing the filter, you will hear unusual
noises. This is normal.
The noises will end during the filter rinsing.
... all coffee machines
h e ating u p ...
DI_02_09_08
Coffee machine heats up.
A warm-up rinsing follows the heating-up
process. This warms up all the pipes.
After each brewing cycle, in the heating up phase
and during the care programs, release water runs
into the drip tray.
 Place acollection container with 120ml
capacity under the combi spout
The warm-up rinsing lasts approx. 40seconds.