WMF 1200F - Page 71

71
User Manual WMF1200F
Technical data
Mains voltage
tolerance range
230V +6 % and –10 %, Mains voltage interruption
<50ms no interruption of function
Water supply
(Constant water supply
optional)
3/8inch hose connector with mains tap, and filter with
0.2to 0.25mm mesh size, on site.
Min. 0.2MPa flow pressure at 2litres/minute,
max.0.6MPa.
Water temperature maximum 35°C.
The set of hoses provided with the new coffee machine
and/or the new water filter must be used. Do not use old
hoses.
Water quality For drinking water with carbonate hardness above
5°dKH, aWMFwater filter should be fitted upstream.
Water drain tube Tube aminimum of DN 19, minimum downward slope of
2cm/m
Ambient temperature +5°C to max. +35°C
(empty the water system in case of frost).
Maximum humidity 80 % relative humidity without condensation.
Do not use device outdoors.
Degree of protection IP X0
Installation surface/
water spray
The device must be placed and leveled on ahorizontal,
sturdy, water-resistant, and heatproof base.
The device must not be cleaned using awater jet. The
device must be installed where it is protected against
water spray. The device must not located on asurface
that is sprayed or cleaned with awater hose, steam jets,
steam cleaner, or similar devices.