WMF 1300 S - Page 13

13
User Manual WMF1300S
Safety
Installation location
• The device can be used as aself-service device if it is supervised
by trained personnel.
The machine must be set up so as to allow good visual access.
•
The device must be placed and levelled on ahorizontal, sturdy,
water-resistant, and heatproof base.
• The device must not be cleaned using awater jet. The device
must be installed where it is protected against water spray.
• The device must not be located on asurface that is sprayed or
cleaned with awater hose, steam jet, steam cleaner, or similar
devices.
Constant water supply
(optional, with constant water model)
• 3/8inch hose connector with water mains tap, and dirt filter
with 0.003in (0.08mm) mesh size, on-site. At least 29psi
(0.2MPa/2bar) supply pressure at 0.53gal/min (2l/min).
Maximum 87psi (0.6MPa/6bar).
Important. If the customer’s on-site flow pressure exceeds
87psi (0.6MPa/6bar), then apressure reducer must absolutely
be connected upstream and set to amaximum of 87psi
(0.6MPa/6bar).