WMF 1300 S - Logo

65
User Manual WMF1300S
Software | Operating options
Logo
Manufacturer's logo
Options: • active
• inactive
Default value:
active
active The manufacturer's logo is shown at the top
right of the “Ready to operate” display.
Customer’s logo
Options: • active
• inactive
Default value:
inactive
active If the customer logo is set to “active,” and
acustomer’s logo has been loaded, then the
customer logo will be displayed centered
in the header (ready to operate display).
Ifvending machines are connected, then the
customer’s logo is displayed on the left. In this
case, both logos cannot be displayed at the
same time.
Load customer's logo
Insert the USB stick containing the customer’s logo.
Load the customer’s logo.
Size of customer’s logo
The logo must not be greater than 80pixels high.
Larger logos will be scaled to this size automatically.