WMF 5000 S+ - Service; Brewer Unit Details; FFC Brewer Portafilter Specifics

13
User Manual WMF5000S +
Safety
Installation location
• The device can be used as aself-service device if it is supervised
by trained personnel.
The machine must be set up so as to allow good visual access.
•
The device must be placed and levelled on ahorizontal, sturdy,
water-resistant, and heatproof base.
• The device must not be cleaned using awater jet. The device
must be installed where it is protected against water spray.
• The device must not be located on asurface that is sprayed or
cleaned with awater hose, steam jet, steam cleaner, or similar
devices.
Water supply
• 3/8inch hose connector with water mains tap, and dirt filter
with 0.003in (0.08mm) mesh size, on-site. At least 29psi
(0.2MPa) (2bar) supply pressure at 0.53gal/min (2l/min).
Maximum 87psi (0.6MPa) (6bar).
Maximum inlet temperature 95°F (35°C).
• The set of hoses provided with the new coffee machine
and/or the new water filter must be used. Do not use the old
set of hoses.
Ambient temperature
• Ambient temperature 41°F to amaximum of 95°F
(+5°Cto amaximum +35°C)