WMF 5000 S+ - Page 51

51
User Manual WMF5000S +
Software | Beverages
Set the cup height manually
The cup height for the beverage is selected using the
setting wheel.
 Use the setting wheel to adjust the height
 On the right side, touch the desired cup symbol to be
assigned to this height
The value is assigned to the cup symbol.
Presence detection using the cup sensor
Cup detection (optional)
The “Detect presence” function causes the Detect cup
button to be displayed.
 Place acup under the spout
 Touch Detect cup
The cup is detected.
The setting for the detected cup height is saved and
shown on the setting wheel on the display.
When set up this way, with active presence detection,
the spout will move to the height saved for the
beverage when the beverage is selected.
Size preselection with cup sensor
The sensor detects the cup height and enables the
beverage if the detected height matches the saved
value.
Use configured cup heights S-M-L
If this button is active, then the cup heights are set in
the system menu.
If this function is active, the height can no longer
be adjusted manually. The setting wheel is no longer
displayed.
For size “S” and “L” beverages,
the size must be selected prior to
selecting the beverage button.
The size can be selected by the cup
sensor only in “Size preselection”
mode.
w page 75
Cup height tolerance
w System w Cup detection
page 74
S‑M‑L must be active. Make cup
settings under
w System w Cup detection
page 74