After buying a new car, users shall pay attention to the running-in of the new motorcycle (the running-in period
is 1,000km at the beginning, and the odometer reading shall prevail). The running-in quality of the new motorcycle
directly affects the service life of the motorcycle, so the user should control the rotation speed to about 6500r/min (the
speed is not more than 50km/h, depending on the speedometer) within the first 1000km. After the running-in period is
completed, an initial maintenance should be carried out to compensate for the initial slight wear, prolong the service life
of the engine and ensure the best performance of motorcycle. Change the company's special oil every 300km. In case
of any engine failure during the running in period and trial operation, please contact the local dealer or the company's
special maintenance service center.
During driving, the speed shall be controlled at about 4,000r/min, and the refueling hand shall control the stroke at
about 1/4. After driving for 1 hour, the engine shall be cooled for (5 ~ 10) minutes.
During driving, the speed shall be controlled at about 5,000r/min, and the refueling hand shall control the stroke at
about 1/2. After driving for 1 hour, the engine shall be cooled for (5 ~ 10) minutes.
When driving, the speed shall be controlled at about 6,000r/min, and the refueling hand should control the stroke
at about 3/4.
Operation of New Motorcycle
To Next Page
Loading...