Inspection of front and rear brakes
The front and rear brakes of this model are equipped with
disc configuration, which has the advantages of stable
braking performance, safety, reliability, labor saving,
excellent heat dissipation, etc. 1. When the free stroke of
the brake handle is greater or less than the standard value,
it needs to be readjusted.
2. Check the oil level of the oil storage cylinder from the
observation hole. When the oil level of the oil storage
cylinder is lower than the lower limit position, the brake oil
shall be replenished to the upper limit position.
3. Check the wear of friction plate and brake disc. If the
thickness of friction plate is less than the maintenance limit
value of 2.0mm and the thickness of brake disc is less than
the limit value of 3.0mm, replace the friction plate and
brake disc.
1
2
2
1. When the brake handle is soft and loose, it indicates
that there is air in the hydraulic brake, which must
be checked and adjusted by our company's special
maintenance service center.
2. Brake oil cannot be mixed with other lubricating
oils. The replaced brake oil cannot be used again, and
different brands of brake oil cannot be mixed, otherwise,
the service performance of hydraulic brakes will be
seriously damaged.
Standard value of stroke of brake handle: 10 mm ~ 20 mm
Recommended brake oil: DOT4
To Next Page
Loading...