1. Motorcycle cleaning
(1) Before cleaning the vehicle, the vehicle must be in the flameout state. After the engine is cooled, block the air outlet
at the tail of the exhaust pipe, and then wash the outside of the vehicle. During cleaning, pay attention to that the water
gun pressure should not be too high, otherwise the lubricating grease will be washed clean (such as wheel bearings,
steering column bearings, oil seals, etc.). (2) When washing the car, try to avoid high-pressure water washing directly into
electrical parts (such as switches, instruments, voltage regulators, relays, etc.), electronic injection parts, and avoid high-
pressure water spraying into internal parts (such as the back of lamps and instruments, slot of storage box, etc.), so as to
prevent electrical short circuit and water entering the storage box. (3). After cleaning, wipe the surface of the motorcycle
with a clean cotton cloth or clean towel. (4). After cleaning, it is necessary to stand for more than 10 minutes so that the
water accumulated on the motorcycle can be drained before starting the vehicle.
2. Storage of motorcycle
(1). Before long-term parking, drain the fuel from the fuel tank and then install the fuel tank cover. Vehicle that have not
been used for a long time should be started at least once a month to avoid blockage of oil passages. (2). Remove the
spark plug, pour 5ml of new lubricating oil into the spark plug hole, inject it into the cylinder, and install the spark plug.
And rotate the engine crankshaft for several turns, so that the injected lubricating oil can be evenly distributed in the
combustion chamber to lubricate the cylinder wall. (3) Remove the battery and charge it slowly for one time. Store the
battery in a dry, dark and indoor environment. Do not store the battery in an overheated or humid environment: below
value, use wood blocks to raise the tire so that the tire does not contact the ground. (5) After storage, it should be stored
in a ventilated, dry, clean, rain-proof and sun-proof environment, away from flammable, chemical corrosive and other
harmful substances. (6). When used after storage, it should be fully cleaned and checked once, then fuel should be added
and the battery should be slowly charged once. If it is stored for more than 4 months, the engine lubricating oil shall be
replaced.
Cleaning and storage
To Next Page
Loading...