Safe driving instruction
4. Precautions for driving braking
The higher the speed of the motorcycle, the longer the braking distance. Therefore, during braking, the brake shall be
controlled according to the vehicle speed and the required braking distance.
easy to produce "floating", resulting in difficulty in controlling the steering mechanism and braking system. So the
drivers shall reduce the speed when driving on rainy days, foggy days and wet roads. When driving at high speed
through the mountain pass, overtaking or passing through the tunnel entrance, it will be affected by the lateral wind.
At this time, the vehicle speed shall be properly controlled to avoid accidental shaking of the vehicle. When using the
motorcycle brake, the user shall first use the rear brake, and then use the front brake to control the running speed of
the motorcycle.
When driving in water or after washing the car, drive at a low speed and gently hold the front and rear brake handles
intermittently to dry the front and rear brakes. After driving on muddy land, sand dune land and roads with poor road
conditions, the brake drum, brake shoe and brake disc shall be cleaned in time to avoid excessive wear
frequently, otherwise the brake will overheat and affect the braking performance, and braking shall be carried out
according to the actual situation. When driving on rainy, wet and slippery roads, it is forbidden to drive at high speed.
5. Precautions for exhaust emission pollution
Please try not to breath the exhaust gas discharged by the motorcycle, because the exhaust gas contains carbon
monoxide (CO), which is harmful to human body. It is strictly prohibited to start and operate the motorcycle in the
garage or other closed areas. The exhaust muffler shall ensure that the exhaust gas is unobstructed without blockage,
so as to facilitate the diffusion of exhaust gas. Check the exhaust muffler for air leakage and ensure that the exhaust gas
diffuses from the tail of the exhaust silencer.
To Next Page
Loading...