Wolf FGB-28 - Assembling the Heat Exchanger

72
3064458_201811
28.9. Assembling the heat exchanger
- Replace the condensate pan gaskets and grease them with silicone grease
- Insert the condensate pans into the casing
- Hook the heat exchanger into place from above
- Press together the retaining clips, guide them straight up and secure them
on the heat exchanger
- The ue pipe must be positioned in the condensate pan
- Ret the trap
- Replace and grease the gaskets
- Fit the pipes to the pump using retaining clips and the threaded connection
- Connect the ow temperature sensor, high limit safety cut-out and ue gas
temperature sensor plugs
- Reconnect the return sensor and pressure sensor plugs
Assembling the heat exchanger
Fitting the condensate pan
Fittingtheowandreturnpipes