Troubleshooting Guide
Engine/Motor and Drive Pulleys Alignment
Troubleshooting Guide doc052711 4-9
4
4.5 Engine/Motor and Drive Pulleys Alignment
1. Install the drive belt.
2. Use a straight edge to align the engine/motor pulley to the drive pulley. Also check that the engine
pulley is within 1/8" square with the drive pulley. Loosen the engine mounting bolts and rotate the
engine if necessary.
3. Check front-to-back movement of the engine does not exceed 6,5 mm 1/4". Tighten the motor mount
U-bolts if necessary.
4. Adjust the drive belt tension to11mm deflection with 7,2 kg. of force.
5. Recheck the pulley alignment and engine squareness with the clutch handle engaged. Adjust if
necessary.
6. Adjust the drive belt support to 6mm from the belt while engaged.
To Next Page
Loading...
