Wood-mizer LT70 Series Operator's Manual

Operation
Operation
1
1-8 doc021820 Operation
 Position the saw head at a height of the first cut;
 If necessary, turn the debarker on;
 Start the blade motor by pressing the START button on the left side of the control panel;
 Push the left joystick forward and hold it in this position.
 Set the feed rate dial to the desired value.
 After making the cut, release the left joystick. Press the STOP button. The blade will be
stopped.
 After position the saw head for the next cut, start the blade motor by pressing the START
button.
NOTE: If none of the pushbuttons, switches or joysticks is used within
5 minutes after switching on the transmitter, the transmitter will turn off
automatically.
When sawing is finished, switch the transmitter off by turning the starting key to the ”0” position.
Remove the key and always store it in a safe place.
NOTE: The starting key (Air-KEY) stores the receiver identification
data. The transmitter cannot communicate with the receiver without
this key. Do not lose the Air-KEY.

Wood-mizer LT70 Series Specifications

General

Hydraulic Log Handling	Optional
Computer Setworks	Optional
Blade Width	1.5 inches (3.8 cm)
Power Options	Electric or diesel
Head Controls	Manual
Cutting Method	Horizontal bandsaw