Operation
Safety
Operation doc021820 1-1
1
SECTION 1 OPERATION
1.1 Safety
CAUTION! This manual is provided as a supplement to the equipment
manufacturer’s manual. Refer to the manufacturer’s manual before
attempting to operate this equipment.
WARNING! Failure to follow the safety precautions may result in radio
equipment failure or serious personal injury.
CAUTION! Wood-Mizer will not bear responsibility for any unapproved
changes or modifications made to the equipment.
Installation
CAUTION! If maintenance is required, the radio must be disconnected
from power. USE PROPER WIRING. Loose or frayed wires can cause
system failure, intermittent operation, machine damage, etc.
CAUTION! DO NOT INSTALL IN HOT AREAS. This apparatus can be
damaged by heat at a temperature of above 70
o
C.
Personal Safety
CAUTION! MAKE SURE THE EQUIPMENT AND SURROUNDING
AREA IS CLEAR BEFORE OPERATING. Do not activate the remote
system unless it is safe to do so.
CAUTION! TURN OFF THE RECEIVER POWER BEFORE
WORKING ON THE SAWMILL. Always disconnect the remote system
before doing any maintenance to prevent accidental operation of the
machine.
CAUTION! IN CASE OF EMERGENCY, immediately press the red
emergency stop switch.
Care
CAUTION! KEEP DRY. Do not clean the transmitter/receiver under
high pressure. If water or other liquids get inside the transmitter
or receiver compartment, immediately dry the unit. Remove the case
and let the unit air dry.
CAUTION! CLEAN THE UNIT AFTER OPERATION. Remove any
mud, dirt, concrete, etc. from the unit to prevent clogging of buttons,
switches, etc. by using a damp cloth.
To Next Page
Loading...
Need help?
General
