Diagnostics and Maintenance
Maintenance
2
2-3 doc021820 Diagnostics and Maintenance
2.2 Maintenance
2.2.1 Daily Maintenance Procedures
Before starting to work:
Make sure that the symbols of all control elements on the transmitter panel are readable.
Replace the transmitter panel if necessary.
Check that the plates on the transmitting unit are intact and readable
Make sure that the mechanical operation of the STOP pushbutton is correct.
During normal operation:
Check that there are not any visible damages to the transmitter.
Make sure that materials that could endanger the transmitter usage and safety (such as:
sawdust, slabs, concrete, sand, dust, lime) are not accumulated on its surface.
After using the Wireless Option:
Clean the transmitting unit: never use solvents or flammable/corrosive materials and do not
use high-pressure water cleaners or steam cleaners;
Store the transmitting unit in a clean and dry place.
Check if the commands sent by the transmitter are correctly performed by the sawmill.
2.2.2 Three-Month Maintenance Procedures
Every three months of operation:
Remove any dust or debris from the transmitter. Never use solvents or flammable/corrosive
materials and do not use high-pressure water cleaners or steam cleaners;
Check that there are not any visible damages to the transmitter.
Make sure that the electrical connections between the receiver and the electric box are not
loose or damaged.
Make sure that the symbols of all control elements on the transmitter panel are readable.
Replace the transmitter panel if necessary.
Check that the plates on the receiver are intact and readable.
If any transmitter/receiver fault occurs, contact your Wood-Mizer Representative. All repairs of the
equipment should be done by authorized persons only.
To Next Page
Loading...
Need help?
General
