Setup
Install the scale
3
Setup WM doc 12/21/223-17
2. Attach the lift cables from the hardware kit on the lift cable rod
(attached earlier to the upright cross channel on the mast). See FIG.
3-10. and FIG.3-31
3. Back out the set screw from the crank shaft with a 3mm hex wrench
and thread the lift cable through the hole in the crank shaft. See FIG.
3-31.
NOTE: The cable should come through shaft
about 1/8" (3mm). If too much of the cable is
pulled through the shaft it will rub on the back
of the saw head. Loctite
TM
or equivalent
should be added to the set screw.
4. Return the set screw and tighten it. See FIG. 1-31.
5. Repeat this procedure on the left side of the sawhead.
Leave room for adjustment up or down.
NOTE: For ease of adjustment, set the left and right side lift cable rods in
approximately the same places on the cross channel.
3.11 Install the scale
1. Slide the scale through the bracket on the mast with the scale facing
the operator, as shown at j in FIG. 1-31.
2. Open and latch the sawhead cover in the open posi-
tions.
3. Loosely secure the sawhead with M8-1.25x20 car-
riage bolts (inserted from the inside of the sawhead,
as in the cut-away view, with washers and nuts on the
exterior, as shown at
kin FIG. 1-31.
4. Slide the anti-vibration blocks onto both sides of the
scale, as shown at
lin FIG. 1-31.
5. Fasten the anti-vibration blocks with the provided
hardware, as shown at
min FIG. 1-31.
The scale should slide freely through the blocks. See FIG.
3-32.
See Section 4.1 Sawmill adjustments
to set the blade ten-
sion and level the scale.
1/8” (3 mm) Max
Set Screw
Lift Cable
Rod
Cable
FIG. 3-31
Washer, M6 Flat
Scale
Bolt, M8-1.25x20
Carriage
Anti-vibration
Block
Bolt, M6-1.0x30
Washer, M8 Flat
Nut, M8-1.25
Nut, M6-1.0
FIG. 3-32
To Next Page
Loading...
