Wood-mizer LX25 - Assemble the bed sections

Setup
Assemble the bed sections
3
Setup LX25 8/25/21 3-5
3.2 Assemble the bed sections
The tools needed are:
 Socket, 15mm
 Ratchet handle
 Ratchet extension bar (optional)
 Combination wrench, 15mm
Assemble the bed on firm, level ground. Failure to do so may cause the sawhead to tip, caus-
ing serious injury or death.
1. Assemble all of the bed sections using track
rails and cross rails, and one cross member
where each bed section joins together.
(See
FIG. 3-1 .)
a. Attach two cross rails per bed sec-
tion. Make sure to place the cross
rails closer together, leaving room
for the sawhead assembly, as
shown.
b. Attach the track rails to the cross
rail. Make sure all of the cross
rails face the same direction.
X100-1045
Wldmnt, Carriage Right Side
Pist
1 130947
Channel, Upright Cross
1
F05005-99
Bolt, M6-1.0x12
4 F05010-200
Nut, M601.0 Nylon
4
F05026-1
Washer, M6 Flat
6 F05089-3
Cable Ties
3
TABLE 1: PARTS BOX CONTENTS
Part # Description Part # Description Qty
WARNING!
TDLX2503-03
Track Rails
Cross Rails
Cross Member
Bolt, M10-1.5x30 HH
Class 8
Nut, M10-1.5 Flanged
Nylon Lock
Washer, M10 Flat
FIG. 3-1