Wood-mizer LX25 - Assemble the Up;Down Crank

Setup
Install the clutch cable
3
3-12 LX25 8/25/21 Setup
1. Thread the clutch cable though the bracket on the operator’s handle by unthreading the upper adjustment nut and slipping
the bare cable through the bracket.
2. Return the adjustment nut to the cable fitting. (See FIG. 3-18 .)
3. Remove the bolt and its two nuts on the throttle handle.
4. Thread the bolt through the cable eye.
5. Return the inner set nut and tighten the outer nut on the throt-
tle handle.
6. Tighten the clutch cable in the bracket with a wrench. (See
FIG. 3-19 .)
NOTE: The throttle should be
adjusted after the LX25 is fully
assembled and ready for use.
NOTE: In addition to the clutch
handle adjustment, the clutch
cable can also be adjusted at the
clutch and at the engine itself.
(See FIG. 3-20 .)
3.8 Assemble the up/down crank
The tools needed are:
 Combination wrench, 19mm
 Small adjustable wrench
 Hex drive, 3mm
100B-007
Upper Adjustment
Nut
Bracket
FIG. 3-18
Bolt, M6-1x70 HHB
Nut, M6 8 FE/ZN5
PN-85/M-82144
Cable Eye
Nut, M6-1.0 Nylon
Lock
FIG. 3-19
100B-016
FIG. 3-20