Wood-mizer LX25 - Level the bed

Setup
Assemble the bed sections
3
Setup LX25 8/25/21 3-7
e. Fully tighten the plate bolts in the slotted holes on
connecting plate.
NOTE: Be sure the slotted holes on the
connecting plate are connected to the
same bed section on both sides of the bed
frame.
f. Repeat for the remaining 3 connections.
g. Attach the cross member between the bed sec-
tions.
NOTE: Optional bed extension sections
may be added at this time, in the same
manner as the standard bed sections.
4. Attach the log clamp in the middle of the bed. (See FIG. 3-4 .)
5. Attach the log rest brackets and posts.Do not tighten until the
bed is leveled.
3.3 Level the bed
The tools needed are:
 Shims
 4 foot level or laser level
 Lag bolts and washers
 Socket and ratchet for lag bolts
 Wooden skids, 4x4 or better
NOTE: It is important that the bed be level for the sawhead to travel smoothly over the rails.
1. Mount the saw bed on wooden skids for leveling and increasing the ground clearance.
A straight 4x4 or 4x6 are an ideal size for the wooden skids. If the skids
are not a solid one-piece section, make sure the seams of skids are
offset from the seams of the bed frame.
(See FIG. 3-5 .)
2. Use a 4-foot level (or laser level) to level the bed in all dimen-
sions. (See FIG. 3-6 .)
3. Adjust the bed for leveling by shimming under low spots.
T100001-4
Washer, 3/8 Flat SAE
Log Clamp
Spacer
Bolt, M10-1.5x140
Washer, 3/8 Flat SAE
Nut, M10-1.50 Hex Nyl Lock
FIG. 3-4
T10002
Wooden Skid
Lag Bolt/washer
FIG. 3-5
T100001-6
Level
FIG. 3-6