Wood-mizer MP280 - Page 7

INTRODUCTION
Machine description
INTRODUCTION doc050624 1-4
1
It is recommended that the MP280 planer/moulder be anchored to the floor using 12 mm screws.
ADDITIONAL PARTS KIT:
 Hex key 4 mm (supplied)
 Hex key 5 mm
 Hex key 6 mm
 Open ended wrench 10 mm (supplied)
 Open ended wrench 30 mm (supplied)
 Adjustable wrench 8" or 10"
 Measuring tape or ruler
 Paraffin oil for the table
 0,5 and 0,3 mm chip breaker
 Fence adjustment bar
 Knife aligment tool
 Nut M20x1,5 (left and right)
FOLLOWING SPACER RINGS ARE SUPPLIED:
 2 x 40 mm height (per cutter)
 2 x 20 mm height (per cutter)
 4 x 2 mm height (per cutter)
 2 x 1 mm height (per cutter)
 2 x 0.5 mm height (per cutter)
 2 x 0.2 mm height (per cutter)
 2 x 0.1 mm height (per cutter)
 2 x 0,3 mm height (per cutter)
These spacer rings are necessary to set the required height.