Setup
Side cutter setup
3
3-19 doc050624 Setup
See Figure 3-12.
3.4 Side cutter setup
WARNING! Before adjusting the knives on this machine always turn
off the electrical circuit supplying power to the machine. Failure to fol-
low this may result in serious injury or death.
WARNING! Wear gloves when working with knives in the machine.
Failure to follow this may result in serious injury or death.
CAUTION! Check for tools used in the operation and remove from the
machine before closing the lid.
IMPORTANT! Check for free rotation of cutter heads before closing
the lid.
TOOLS NEEDED:
12 mm open-end wrench.
30 mm open-end wrench (supplied).
4 mm hex wrench (supplied).
FIG. 3-12
To Next Page
Loading...
