Setup
Setup of upper and lower cutter heads
Setup doc050624 3-6
3
EVERY TIME BEFORE STARTING THE MACHINE:
Check that no tools have been left in the planer/moulder.
Check that the cutters can rotate freely before the safety doors are closed.
Review the safety instructions!
Be sure the emergency switch button is released;
Be sure the upper cover is closed and the limit switch is activated. Be sure all
machine’s parts are tightened, especially working element covers.
Be sure that no one than operator is in the high risk area.
Turn on the chip extractor.
DANGER! Connect the planer/moulder electrical
installation. Check the rotational direction. Looking from the
transmission, the upper cutter must rotate in the opposite
direction to the material feed direction (to the left).
3.3 Setup of upper and lower cutter heads
WARNING! Before adjusting the knives on this machine always turn
off the electrical circuit supplying power to the machine. Failure to fol-
low this may result in serious injury or death.
WARNING! Wear gloves when working with knives in the machine.
Failure to follow this may result in serious injury or death.
WARNING! Check for tools used in the operation and remove from the
machine before closing the lid. Failure to follow this may result in seri-
ous injury or death.
CAUTION! Check for free rotation of cutter heads before closing the
lid.
The cutter heads come shipped with two straight planer knives pre-installed. Check these
knives to ensure that the factory settings have not been altered during shipping.
To Next Page
Loading...
