PLANER/MOULDER SPECIFICATIONS
Dust/Chip Extractor Specifications
7
7-8 doc050624 PLANER/MOULDER SPECIFICATIONS
See table 7-8. A relation between the pattern knife protrusion and the thickness is shown below.
7.3 Dust/Chip Extractor Specifications
See Table 7-9. Specifications of the dust/chip extractors used on the MP280 are listed below.
The pressure drop between the inlet of the capture device and the connection to the CADES should be maximum 1,5
kPa (for the nominal air flow rate). If the pressure drop exceeds 1,5 kPa the machine might not be compatible with
conventional CADES.
IMPORTANT! The dust extractor hoses must be grounded or made
with materials not accumulating electrostatic charge.
CAUTION! Always turn on the dust extractor before starting the
machine
Pattern knife thickness Pattern knife max.
protrusion
1
1
According to EN 847-1:2005 European Standard
3 mm 13 mm
4 mm 21 mm
5mm 29 mm
TABLE 7-8
Airflow
4000 m
3
/h
Inlet diameter 3x100mm
1x125 mm
Motor power 3 kW
Number of sacks 4 pcs
Sack capacity --
Recommended conveying air
velocity in the duct
25 m/s
TABLE 7-9
To Next Page
Loading...
