AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
18 19
Operation
• Press the READ button again in order to carry out a second mea-
surement – the measurement value appears in the upper section of
the display;
• Press the +/= button again in order to display the sum in the bottom
section of the display;
• By repeating the above steps, the addition is continued.
Addition (with M+storage)
• Carry out the measurement. Save the final result by keeping the
MODE button pressed for at least 2 sec., until a double beeping
tone sounds. “M+“ will appear in the display.
• Start new measurement as described - press the READ button;
• Press the +/= button in order to switch into the addition mode – “+”
will appear in the display;
Tips:
A. The measured object should have a hard surface and not be blocked by
obstacles;
B. In order to obtain precise results, select a large, smooth, hard surface;
C. If the measured surface is too small, irregular or too soft, chipboard
can be used on the surface of the measured object;
D. This device can not be used to measure through glass;
E. The device should be further than 60 cm away from the measured
object during measurement;
F. In order to achieve a more precise measurement result, the temperature
of the device should correspond to the environmental temperature.
Addition (without M+storage)
• Press the READ button – the measurement value appears in the
upper section of the display;
• Press the +/= button in order to enter the addition mode – the “+”
symbol appears in the display and the result will be shown in the
bottom section of the display at the same time (press the +/= button
again in order to stop the addition);
Operation
To Next Page
Loading...
Need help?
General
