AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
14 15
Operation
Avoiding measurement errors
Note the following points in order to avoid measurement errors:
1. Measurements through glass are not possible
2. Distance measurement of sound-absorbent items (e.g. curtains) is not
possible.
3. Measurement errors can occur depending on the surface quality of
the object opposite.
4. The device must be aligned at 90° to the surface opposite (use spirit
level).
5. Strong wind can lead to measurement errors.
6. Objects between the measurement object and the device can affect the
precision of measurement.
7. With distance measurement in the maximum distance range, mea-
surement errors can occur (measurement range 0.6 – 16 m / 2 – 53 ft.).
• If the measured distance is outside of the indicated area:
• If the measured result is outside of the indicated area: The error
message “Err” is shown in the bottom row of the display.
8. With the addition of various parameters (e.g. length plus area), the
“+” is ignored and the display shows the same result as the previous
measurement.
Insert battery
Open the battery compartment cover on the
reverse of the device, pull the connector forward
slightly and press the battery (9 V block battery,
size 6F22) onto the connector. Insert the battery
into the compartment and close the compart-
ment cover.
Displays
A) Plus
B) Length/area/volume L=length W=width H=height
C) Measurement display from where the device measures.
D) Memory
E) Memory, calculation result
F) Current measurement result
G) Displayed with insufficient power supply
H) square foot
I) Cubic foot
J) Metre / square metre / cubic metre
Operation
To Next Page
Loading...
Need help?
General
