AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
24 25
Volume addition in the volume mode:
• Press the MODE button in order to store the calculated volume
from the first measurement – the “M+“ symbol appears in the display;
• Press the MODE button in order to delete the currently displayed
data – now the second measurement and calculation can be carried
out (follow steps 1 and 3 under the “Volume” section).
• After obtaining the calculated second volume, press the +/=
button, in order to switch into the addition mode. The “+“ symbol
will appear in the display. A double beeping tone will sound;
• Add the content of the memory to the last measurement result:
Keep +/= button pressed down until a double beeping tone
sounds. “M+” will disappear from the display, only the value from the
memory will now appear in the lower row of the display.
• The width symbol “W“ in the display flashes to indicate the next
measurement to be carried out. Press the READ button in order to
measure the width, the result appears in the upper section of the
display. (Step 2);
• The height symbol “H“ in the display flashes and indicates the next
measurement to be carried out. Press the READ button in order to
measure the height, the result appears in the upper section of the
display. (Step 3);
• The repeated pressing of the READ button switches back and forth
in the upper section of the display between the length, width and
height;
• Press the MODE button in order to delete the data from the display
− now, a new volume calculation can be carried out;
− in order to switch into the measurement mode, press the MODE
button again.
Tips:
With the individual pressing of the MODE button, you can switch back
and forth between the length, area and volume. If data is available on
the display, the pressing of the MODE button will delete the current
data – the mode remains unchanged.
Operation Operation
To Next Page
Loading...
Need help?
General
