Chain Saw WG303E
13
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain is
automatically oiled during operation.
FILLING OIL TANK:
1. Set chain saw on any suitable surface with oil filler
cap facing upward.
2. Clean area around the oil filler cap with cloth and
unscrew the cap by turning it counter clockwise.
3. Add bar and chain oil until reservoir is full.
4. Avoid dirt or debris entering oil tank, refit Oil Filler
Cap and tighten by turning clockwise until hand tight.
IMPORTANT: To allow venting of the oil
reservoir, small breather channels are
provided between the oil filler cap and the
strainer, to prevent leakage ensure machine is
left in a horizontal position (Oil Filler Cap (4)
uppermost) when not in use.
It is important to use only the recommended oil
to avoid damage to the chain saw. Never use
recycled/old oil. Use of non approved oil will
invalidate the warranty.
CHECKING THE AUTOMATIC OILER
Proper functioning of the automatic oiler can be checked
by running the chain saw and pointing the tip of the
Guide bar (7) towards a piece of cardboard or paper
on the ground. If an increasing oil pattern develops on
the cardboard, the automatic oiler is operating fine. If
there is no oil pattern, despite a full oil reservoir, contact
WORX customer service agent or WORX approved
service agent.
CAUTION: Do not touch the ground with the
chain. Ensure safety clearance of 30cm.
OPERATION
1. SWITCHING ON AND OFF (See Fig. F)
ATTENTION: Check the voltage and current
supply: The voltage and current supply must
comply with the ratings on the product plate.
For switching on the tool, press the Lock-off Button
(3), then fully press the On/Off Switch (2) and hold in this
position. The lock-off button can now be released.
For switching off, release the on/off switch.
After sawing, do not stop the chain saw by activating the
Chain Stop Lever (Hand Guard) (5).
2
3
F
To Next Page
Loading...
