Chain Saw WG303E
3
do the job better and safer at the rate for
which it was designed.
b) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool’s operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of the
power tool for operations different from
those intended could result in a hazardous
situation.
5. SERVICE
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
CHAIN SAW SAFETY
WARNINGS
1. Keep all parts of the body away
from the saw chain when the chain
saw is operating. Before you start
the chain saw, make sure the saw
chain is not contacting anything. A
moment of inattention while operating
chain saws may cause entanglement
of your clothing or body with the saw
chain.
2. Always hold the chain saw with
your right hand on the rear handle
and your left hand on the front
handle. Holding the chain saw with a
reversed hand configuration increases
the risk of personal injury and should
never be done
3. Hold the power tool by insulated
gripping surfaces only, because
the saw chain may contact hidden
wiring or its own cord. Saw chains
contacting a “live” wire may make
exposed metal parts of the power tool
“live” and could give the operator an
electric shock.
4. Wear safety glasses and hearing
protection. Further protective
equipment for head, hands, legs
and feet is recommended. Adequate
protective clothing will reduce personal
injury by flying debris or accidental
contact with the saw chain
5. Do not operate a chain saw in a
tree. Operation of a chain saw while up
in a tree may result in personal injury.
6. Always keep proper footing and
operate the chain saw only when
standing on fixed, secure and level
surface. Slippery or unstable surfaces
such as ladders may cause a loss of
balance or control of the chain saw.
7. When cutting a limb that is under
tension be alert for spring back.
When the tension in the wood fibres is
released the spring loaded limb may
strike the operator and/or throw the
chain saw out of control.
8. Use extreme caution when cutting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
