Chain Saw WG303E
18
When the log is supported on both ends, as illustrated,
cut 1/3 the diameter from the top overbuck. Then make
the finished cut by underbucking the lower 2/3 to meet
the first cut (See Fig. Q).
WARNING (See Fig. R)
• If on slope, make sure log will not roll down hill.
Secure log by using wooden stakes. Drive wooden
stakes into ground on downhill side of log. Stand
on uphill side of log while cutting. Log may roll after
cutting.
• Never try cutting through two logs at same time. This
could increase the risk of kickback.
• While cutting log, never hold log with your hand, leg,
or foot.
• While cutting log, never allow another person to hold
log.
• Turn off and unplug saw before moving from one
place to another.
MAINTENANCE
Before any work on the machine itself, pull the
mains plug from the socket.
NOTE: To ensure long and reliable service, carry out the
following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged chain and guide bar, loose
fixings and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using the chain saw.
If the chain saw should happen to fail despite the care
taken in manufacturing and testing, repair should be
carried out by an authorized customer service agent.
Before returning, ensure all oil in the oil tank has
been emptied.
BAR MAINTENANCE
To maximize bar life, the following bar maintenance is
recommended.
The bar rails that carry the chain should be cleaned
before storing the tool or if the bar or chain appear to be
dirty.
The rails should be cleaned every time the chain is
removed.
TO CLEAN THE BAR RAILS:
1. Remove chain cover and bar and chain (see section
ASSEMBLY).
1
2
2/3
1/3
Q
R
To Next Page
Loading...
Need help?
General
Weight and Dimensions
