Worx WG303E User Manual

Chain Saw WG303E
21
TROUBLESHOOTING
Symptom Possible Cause
Chain saw fails to
operate
Kickback brake is activated
No power
Mains socket faulty
Extension cord damaged
Fuse faulty
Pull hand guard back in position
(Figure G)
Check power
Use another socket
Check cord, replace
Replace fuse
Chain saw operates
intermittently
Extension cord damaged
Loose connection
Internal wiring defective
On/Off switch defective
Check cord, replace
Contact service agent
Contact service agent
Contact service agent
Dry chain
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Refill oil
Clean cap
Clean oil passage outlet
Kickback Brake / Run
down brake
Brake does not stop chain Contact service agent
Chain/chain bar
overheats
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain is over tensioned
Dull chain
Refill oil
Clean cap
Clean oil passage outlet
Adjust locking knob
Sharpen chain or replace
Chain saw rips, vibrates,
does not saw properly
Chain tension too loose
Dull chain
Chain worn out
Chain teeth are facing in the
wrong direction
Adjust locking knob
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
Never use tools with defective On/Off switches or defective Kickback brake (Hand Guard).
In the case of all other types of technical faults, please contact helpline or local service center.

Worx WG303E Specifications

General

Power source	AC
Chain speed	12 m/s
Product color	Black, Orange
Oil tank capacity	0.2 L
Oil level indicator	Yes

Weight and Dimensions

Weight	4800 g