Chain Saw WG303E
20
LUBRICATE SPROCKET
WARNING: Wear heavy duty gloves when
performing an maintenance or service to this tool.
Always unplug the tool before performing any service or
maintenance on this tool.
NOTE:
It is not necessary to remove the chain or bar when
lubricating the sprocket.
1. Clean the bar and sprocket
2. Using a grease gun, insert the tip of the gun into the
lubrication hole and inject grease until it appears at
the outside edge of the sprocket tip (See Fig. T).
3. To rotate the sprocket release the chain stop and pull
the chain by hand until the ungreased side of the
sprocket is in line with the grease hole. Repeat the
lubrication procedure.
CLEANING/STORAGE
Clean the moulded plastic housing of the chain saw
using a soft brush and clean cloth. Do not use water,
solvents or polishes. Remove all debris, especially from
the motor cooling vents.
Remove and brush clean the cover plate, chain and chain
bar after 1 to 3 hours of use. Clean the area under the
cover plate, the drive sprocket and chain bar assembly
using a soft brush. Clean oil outlet with a clean cloth.
If the chain saw is to be stored for a longer period of
time, clean chain and chain bar.
Store in a secure, dry place out of the reach of children.
Do not place other objects on the chain saw.
To prevent leakage ensure machine is left in a horizontal
position (oil filler cap 4 uppermost).
When storing machine in original packaging the oil tank
must be completely emptied.
Injecting grease to lubricate
T
To Next Page
Loading...
