Worx WG303E User Manual

Chain Saw WG303E
7
SYMBOLS
Read the manual
WARNING
Wear ear protection
Wear eye protection
Wear dust mask
Gloves with saw protection
Boots with saw protection, steel toe-
cap and non-slip sole
Correct Direction of Cutting-Teeth
Chain stop
Tip contact may cause the guide
bar to move suddenly upward and
backwards, which may cause serious
injury to user.
Contact of the guide bar tip with any
object should be avoided
Do not use one handed when
operating the chain saw.
Always use two hands when
operating the chain saw.
Double insulation. When servicing,
use only identical replacement parts.
Do not expose to rain
Remove plug from the mains
immediately if the cable is damaged
or cut.
RCM approval mark
2
nd
cut overbuck (2/3 diameter) to
meet 1
st
cut (to avoid pinching)
1
st
cut underbuck
(1/3 diameter) to
avoid splintering
Figure 5 – Log supported on end
1
st
cut overbuck (1/3 diameter)
to avoid splintering
2
nd
cut underbuck (2/3 diameter)
to meet 1
st
cut (to avoid pinching)
Figure 6 – Log supported both ends
Stand on uphill side when cutting because log may roll
Figure 7 – Bucking a log

Worx WG303E Specifications

General

Power source	AC
Chain speed	12 m/s
Product color	Black, Orange
Oil tank capacity	0.2 L
Oil level indicator	Yes

Weight and Dimensions

Weight	4800 g