Worx WX520 Series - Operation; Maintain Tools with Care

13
20V Cordless Brushless Circular saw EN
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the job.
This may significantly reduce the exposure level over the
total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
WARNING: Do not release the handle until the saw
blade come to complete stop and do not touch
saw blade while the saw blade is running.
INTENDED USE
The tool is intended for ripping and cross-cutting wood
and other materials in straight cutting lines, while
resting firmly on the work piece.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery back See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY
Saw blade assembly and removing
NOTE: Depress the spindle lock
button to lock or loosen the blade
bolt.
WARNING: Always remove
the battery before changing
the blade!
See Fig. B
Cutting depth adjusting See Fig. C
Base plate angle adjusting See Fig. D1, D2
OPERATION
Safety On/Off Switch
WARNING: To avoid cutting
injury from the sharp blade,
please don’t put your hands around
the base plate.
NOTE: Keep the dust adaptor
connected to dust collecting
device when using the tool.
See Fig. E
Rip and Cross Cutting
NOTE: The cutting line of saw blade
is aligned with the cutting mark 0
0
.
See Fig. F1, F2
Bevel cuts See Fig. G
Parallel guide See Fig. H1, H2
Sawdust removal See Fig. I
WORKING HINTS FOR YOUR TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduce the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
the tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material being
cut.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH CARE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional