20V Lithium-Ion Cordless Circular Saw
EN
19
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
operating the on/off switch.
Battery park not plugged
in.
Battery park is powered off.
Carbon brush has worn
down
Check to make sure battery park
is connected well into a working
outlet
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Cutting depth is less than
that is set.
Sawdust accumulated at
the rear of the base.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly
engaged with the spindle.
Remove the blade, and
reassemble it as described in
SAW BLADE ASSEMBLY AND
REMOVING section.
Blade will not cut a straight
line.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Mount a new, sharp blade on
the saw.
Check that blade is properly
mounted.
Use a parallel guide.
Blade kicks back when
beginning a cut
Blade is not spinning fast
enough
Allow the saw blade to reach full
speed prior to beginning a cut in
the material.
To Next Page
Loading...
