Product Safety Information
975-0799-01-01 ix
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, BURN, OR
ARC FLASH
l
Apply appropriate personal protective equipment (PPE) and
follow safe electrical work practices. See NFPA 70E or CSA
Z462.
l
This equipment must only be installed and serviced by
qualified electrical personnel.
l
Never operate energized with the wiring compartment cover
removed.
l
Energized from multiple sources. Before removing the wiring
compartment cover - identify all sources, de-energize, and
wait 2 minutes for circuits to discharge.
l
Always use a properly rated voltage sensing device to
confirm all circuits are de-energized.
l
Replace all devices, doors, and covers before turning on
power to this equipment.
Failure to follow these instructions will result in death or serious
injury.
WARNING
ELECTRICAL SHOCK HAZARD
l
Replace the wiring compartment cover before turning on
power to this equipment.
l
Use a torque screwdriver to tighten the captive nut panel
screw to 5 in-lb torque to ensure a proper ground connection
and a required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
WARNING
FIRE AND EXPLOSION HAZARD
l
Unit’s components may produce arcs or sparks.
l
Do not install near batteries, in machinery space, or in an
area in which ignition-protected equipment is required.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
Areas include any space containing gasoline-powered machinery,
fuel tanks, as well as joints, fittings, or other connections between
components of the fuel system.
To Next Page
Loading...
Need help?
General
