4-20 DocuTech 128/155/180 HighLight Color Operator Guide
Problem Solving
Figure 4-19 Area 20
6. Remove any paper from the exposed area.
7. Press the green lever down and to the left until the latch
catches.
8. Close the bypass transport module door.
Clearing a misfeed (feeder tray fault)
NOTE: High volume printer configuration only
1. If the Ready to Open indicator is not lit, press the Tray Unlock
button located on the feeder tray control panel.
Figure 4-20
2. When the Ready to Open indicator lights, open the feeder tray.
Pull the tray all the way out for best results.
To Next Page
Loading...
