Xerox 701P44148 - Job Type

FreeFlow Scanner 665E Operator Manual
5-7
5. Job Ticket/Job Setup
Job Type: Select the specific job type from the drop-down list. There are
three primary job types, some with subtypes:
• Standard: Prints the document pages in sequential order,
using single sheets of paper stock. A standard job can be
1-sided (simplex), 2-sided (duplex) or Head-To-Toe (duplex).
• Signature: Prints the document pages non-sequentially, to
produce folded output. Signature jobs are always duplex.
Some finishing options may be disabled when printing
signatures. You can use the Autofit option to scale images in a
Signature job in the job ticket.
– Book signatures: Document width is greater than
the height, and pages are duplex.
– Calendar signatures: Document height is greater
than the width, and pages are head-to-toe.
– Pamphlet signatures: Document height is
greater than the width, and pages are duplex.
• N Up: Prints the same page an N amount of times on the
output paper. The options available for each N Up option differ
for each N Up option.
– 2-Up: Prints the same page twice, side by side,
on one side of a page. You can change the paper size, if
necessary. Image Shift is not available.
– 2-Up flip left: Prints the same page twice, side
by side, on one side of a page, with the left-side image
rotated 180 degrees. You can change the paper size, if
necessary. The Orientation depends on the N-Up type you
choose. Image Shift is not available for 2-Up flip left. This
option is often selected when using offline cutting and
binding.