Xerox AltaLink B8045 Installation And Configuration Guide

SolutionPossible CauseProblem
Verify that Network Time Protocol is
set up correctly, refer to Enable NTP
Service.
NTP not enabled or properly con-
figured.
Invalid Timestamp. Authentication
failed due to a time or date differ-
ence between the device and the re-
mote server, or Domain Controller.
GMT offset is not set correctly.
• If you are not using DHCP, verify
the date and time and GMT Off-
set, or Time Zone is correct. In-
structions are available in the
System Administrator Guide.
• Verify that GMT offset is correct
for Daylight Savings Time.
Note
Unforeseenerrors are mapped to
this error message.
The IP Address is incorrect or was re-
set.
Cannotsee the Internet Services web
page.
• Check the IP Address printed on
the configuration report. Ensure
the DHCP settings match your
site settings.
• To print a configuration report at
the Xerox
®
device, select Device,
then Information Pages. Select
the Configuration Report from
the list, then select Print.
Xerox
®
AltaLink
®
Series4-4
Smart Card Installation and Configuration Guide
Troubleshooting

Xerox AltaLink B8045 Specifications

General

Print Speed	Up to 45 ppm
Monthly Duty Cycle	Up to 200, 000 pages
Automatic Duplexing	Yes
Control Panel	10.1-inch color touchscreen
Functions	Print, Copy, Scan, Fax
Memory	4 GB
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Connectivity	Ethernet, USB, Wi-Fi
Scanner Type	Duplex Automatic Document Feeder
Copy Speed	Up to 45 ppm
Mobile Printing	Apple AirPrint, Google Cloud Print
Print Resolution	1200 x 1200 dpi
Hard Drive	320 GB (optional)