2. Remove the imaging unit.
Warning: Do not expose the imaging unit to direct light for
more than 10 minutes. Extended exposure to light may
cause print quality problems.
Warning: Do not touch the photoconductor drum. Doing so
may affect the quality of future print jobs.
3. Open the rear door.
CAUTION—HOT SURFACE: The inside of the printer might
be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching it.
4. Remove the jammed paper.
Note: Make sure that all paper fragments are removed.
5. Close the rear door.
6. Insert the imaging unit.
7. Close the front door.
10
To Next Page
Loading...
