Xerox B315 - Use Recommended Paper; Identifying Jam Locations; Paper Jam in the Automatic Document Feeder (ADF); Paper Jam in the Standard Output Tray

• Make sure that the paper guides are positioned correctly and are
not pressing tightly against the paper or envelopes.
• Push the tray firmly into the printer after loading paper.
UUssee RReeccoommmmeennddeedd PPaappeerr
• Use only recommended paper or specialty media.
• Do not load paper that is wrinkled, creased, damp, bent, or curled.
• Flex, fan, and align the paper edges before loading.
• Do not use paper that has been cut or trimmed by hand.
• Do not mix paper sizes, weights, or types in the same tray.
• Make sure that the paper size and type are set correctly on the
computer or printer control panel.
• Store paper according to manufacturer recommendations.
IIddeennttiiffyyiinngg JJaamm LLooccaattiioonnss
• When Jam Assist is set to On, the printer might attempt to flush
blank pages or pages with partial prints after clearing the jam.
Check your printed output for blank pages.
• When Jam Recovery is set to On or Auto, the printer reprints
jammed pages.
1. Automatic
Document Feeder
(ADF)
2. Output Tray
3. Multipurpose
Feeder
4. Trays
5. Duplex Unit
6. Rear Door
PPaappeerr JJaamm iinn tthhee AAuuttoommaattiicc DDooccuummeenntt
FFeeeeddeerr ((AADDFF))
1. Remove all original documents from the ADF tray.
2. Open the ADF cover.
3. Remove the jammed paper.
Note: Ensure that all paper fragments are removed.
4. Close the ADF cover.
PPaappeerr JJaamm iinn tthhee SSttaannddaarrdd OOuuttppuutt TTrraayy
1. Raise the scanner, and then remove the jammed paper.
Note: Ensure that all paper fragments are removed.
2. Lower the scanner.
12