TWAIN Scanning Guide Document Settings
26 User’s Guide
If the Document size list does not include the document size for your scanning batch, click in one
of the fields below the document size list. Input the width of the document in the first field, then
input the length in the second field. You can only specify values within the scanner's minimum
and maximum supported item size. Please refer to the maintenance section of the scanner user's
guide for this information.
Long Document
Select Long document to enable support of paper sizes up to the scanner maximum. After you
select this option make sure you input the page length for your document in the custom input
field, located below the Document size selection list.
Note that some of the options in the scanner interface cannot be used when the page length will
be greater than inches (depending on the scanner model). When you select this option,
incompatible options will either be automatically disabled or the setting will simply be discarded
while scanning.
Manual Feed
Select this option to enable a delay from when the last page is scanned and when the scanner
stops the scan job. This allows you to scan one page at a time without having to click Scan for
each page you put in the scanner.
To scan with manual feed mode:
1. Select Manual feed in the scanner’s interface.
2. In the Timeout field, input the amount of time you want the scanner to wait from when the
last page is scanned and when the scanner stops scanning.
3. Place a document in the scanner.
4. Click Scan.
5. The scanning progress dialogue on-screen will display a countdown indicating how much
time you have to place the next document in the scanner.
6. When you are done scanning all pages in your document, you can click on Done to stop the
timer or simply let the timer run out.
Detect Double Feeds
Detect double feeds is the scanner's ability to detect when two or more pages are fed through the
scanner at the same time. When this option is turned on, ultrasonic waves are aimed at the
document to detect multiple pages by the level at which the waves pass through the pages. The
accuracy of this sensor depends on paper thickness and whether or not creasing is in the original
document.
Note: This option is available in the interface only if the connected scanner supports this feature.
To Next Page
Loading...
Need help?
General