Paper Guide B-1
B
Printing with tabs
A special tabs guide is installed on the trail edge paper guide after tab stock is loaded into the
paper tray. The tabs guide prevents the fluffers from blowing sheets with short tab extensions
away from the lead edge of the tray.
Two tabs guides are included with each feeding module. One is labeled A4/11" and the other is
A5/5.5". These tab guides are mounted on brackets or in a molded pocket that is located inside
the Feed Module front door.
• When using the A4/11" tabs guide, tab page size is 9 x 11 inches (A4 tab size 223 x
297mm) and body page size is 8.5 x 11 inches (A4 210 x 297mm).
• When using the A5/5.5" tabs guide, tab page size is 8.5 x 6 inches (A5 tab size 161 x
210mm) and body page size is 8.5 x 5.5" (A5 148 x 210mm).
Note
Check with your service representative if you are not sure that you have the required
hardware for running tabs.
The A4/11" tabs guide can be installed in any tray. The A5/5.5" tabs guide can only be installed
in Trays 1 and 2.
The tabs guide should be removed from the tray once tab printing is completed. This will reduce
the chance of damaging the tabs guide when loading normal paper.
It is recommended that tab jobs be sent to the stacker cart, not to a stacker top tray (unless the
stock size is smaller than the 7x10 inch (178x254 mm) size limitation of the stacker). When
running tab stock, the quality of the stack on the stacker cart may be affected due to the
structure of the media.
Once the tabs guide is installed, program jobs according to the procedures for programming tab
jobs.
Obtaining additional tab guide kits
If additional Feed Module Tab Guide kits (Part #600K14630) are needed, contact your Xerox
Service Representative. The additional kits are customer installable and include installation
instructions.
To Next Page
Loading...
Need help?
General