Paper Guide D-1
D
Managing Finishers
and Stackers
Finisher procedures
From the Printer menu, select Finishing and/or Stacking to view a list of finishers and
information about them, including whether the finisher is enabled or disabled and how each
finisher is programmed.
Stacker Limitations
The DS5000 Stacker can stack up to 5000 sheets of 20-pound (75 gsm) bond paper. There is
one stacking tray although the stacker comes with two interchangeable stacking carts.
The DS3500 can stack up to 3500 sheets of 20-pound (75 gsm) bond paper. The device also
transports the sheets from the print engine to the stacker and is able to reregister and rotate
sheets. The DS3500 also has a Top Tray that can be used as a valid destination and purge tray.
The minimum size sheet that the stackers can accept is 7 inches (178 mm) in the process
direction and 10 inches (254 mm) in the cross-process direction. Any paper smaller than these
dimensions can be programmed to the top tray, but not to the stacker.
To Next Page
Loading...
Need help?
General