Paper Guide C-1
C
Managing the
Feeder
Feeder procedures
The paper trays can either be programmed then loaded or loaded then programmed.
For more information, see the Configuring Paper Stocks and Tray Settings section of the Xerox
Nuvera User Guide and Training Aid
From the Printer menu, select Paper Trays for a list of paper trays and information about
individual trays, including whether the tray is active or inactive, how much stock is in the tray,
and which stock is assigned to the tray.
Note
Paper tray programming for the Inserter is the same as for the Feeder. Refer to Inserter
procedures for specific instructions.
Add stock to a tray directly from the Stock Library window
1. From the Printer menu, select Stock Library.
2. Select the stock to be assigned to a feeder tray. The table row is highlighted.
3. Select [Stock: Add to Trays].
4. Select the destination tray.
5. Select [OK].
6. Load the stock in paper tray.
CAUTION
An incorrect value for any stock attribute can cause faults or unacceptable image quality.
To Next Page
Loading...
Need help?
General