Xerox Phaser 3150 - Using a Postscript Driver in Windows; Installing a Postscript Driver

6
Using a PostScript Driver
Using a PostScript Driver in
Windows
Installing a PostScript Driver
N OTE : The following procedure bases on Windwos XP. The steps
for installing PostScript driver may vary depending on the
Operation System you are using.
1 Place the CD-ROM which came with your printer into the
CD-ROM drive.
2 Click the Start menu.
3 For Windows 98/Me/NT 4.0/2000, select Settings and then
Printers .
For Windows XP, select Printers and Faxes .
4 For Windows 98/Me/NT 4.0/2000, double-c lick Add Printer .
For Windows XP,
c lick Add a printer .
5 Add Printer Wizard opens. Click Next .
6 Select Local printer attached to this computer and click
Next .
7 Select the port you want to use and click Next .
8 Click on Have Disk , and then choose:
• for Windows 9x, x:\P3150\Printer\AddPrinter\PS\
ENGLISH
(or the desired language) \Win9x\ setup.inf .
• For Windows NT 4.0,
x:\P3150\Printer\AddPrinter\
PS\ENGLISH
(or the desired language) \Winnt\ setup.inf .
• For Windows 2000,
x:\P3150\Printer\AddPrinter\
PS\ENGLISH
(or the desired language) \Win2k\ setup.inf .
• For Windows XP,
x:\P3150\Printer\AddPrinter\
PS\ENGLISH
(or the desired language) \Winxp\ setup.inf .
(where x is the designated drive letter for the CD-ROM
drive)
Then click
OK .
wzUGGwG]GGmSGqGX]SGYWW[GGXa\ZGwt