58 Setting the PCL Mode
Symbol Set
Sets the font for symbols. The default is [ROMAN-8].
Font Size
Sets the font size within the range of 4.00 to 50.00 pt in increments of 0.25 pt. The
default is [12.00].
Font Pitch
Sets the font pitch (number of characters per inch) within the range of 6.00 to 24.00
cpi in increments of 0.01 cpi. The default is [10.00].
Form Line
Sets the form line (number of lines within one form) within the range of 5 to 128 lines
in increments of 1. The default is [64].
Quantity
Sets the number of copies to be printed within the range of 1 to 999. The default is
[1 Set(s)].
Image Enhance
Image Enhance is a feature that artificially increases resolution by smoothing out
transitions between black and white and reducing jagged appearance. Set whether
or not to enable Image Enhance by selecting [On] (default) or [Off].
HexDump
HexDump is a feature that prints the contents of data in ASCII codes (hexadecimal
format). Set whether or not to enable HexDump by selecting [Enable] or [Disable]
(default).
Draft Mode
Enabling Draft Mode uses less toner when printing. This mode increases print
speed but decreases print quality. Set whether or not to enable Draft Mode by
selecting [Enable] or [Disable] (default).
Line Termination
Sets the line termination control codes. Set how you want the printer to interpret
CR, LF and FF control codes. The optional values and their interpretations are as
follows:
Optional
Values
CR
Interpretation
LF
Interpretation
FF
Interpretation
Off (default) CR LF FF
Add-LF CR + LF LF FF
Add-CR CR CR + LF CR + FF
CR-XX CR + LF CR + LF CR + FF
To Next Page
Loading...
Need help?
General